Custom Audio Electronics KPM150H, Руководство пользователя

Страница: 37 / 96

NOTCH DISTANCE
“Notch Distance” is the minimum distance (in mm) between the upper edge of ticket
and the notch (see chapter 10).
The numeric value of the distance is made up with the following four parameters
for the setting of three digits (two for the integer part of the number and one for the
decimal part) and of the sign:
NOTCH DISTANCE SIGN
Sign setting:
+ D = positive distance
- = negative distance
NOTCH DISTANCE [mm x 10]
Setting the digit for tens:
0 D 3 6 9
1 4 7
2 5 8
NOTCH DISTANCE [mm x 1]
Setting the digit for units:
0
D
3 6 9
1 4 7
2 5 8
NOTCH DISTANCE [mm x .1]
Setting the digit for decimals:
0
D
3 6 9
1 4 7
2 5 8
NOTE: For example, to set the notch distance to 15 mm, modify the parameters as follows:
Notch Distance Sign = +
Notch Distance [mm x 10] = 1
Notch Distance [mm x 1] = 5
Notch Distance [mm x .1] = 0
NOTE: If the “Notch Position” parameter is disabled, the parameters for the “Notch Distance” are not
printed.
TICKET LOCKING
This parameter enables/disables the block of the paper inside the device where the
ticket is not cut with the cutter, but is presented for the manual tear off by the user:
Disabled
D
= paper block disabled
Enabled = paper block enabled
NOTE: If the “Notch Position” parameter is disabled, the parameter is not printed.
PAPEREND BUFFER
CLEAR
Cleaning mode of the data in receive buffer, if the printing is stopped due to lack of paper:
Disabled
D
= The data remain in the receive buffer. When the paper runs out, the
printer keeps the remaining data in the receive buffer and prints the
remaining portion of the ticket after that the new paper is loaded.
Enabled = When the paper runs out, all data in the receive buffer are deleted.
TICKET MANAGEMENT
This parameter allows the ticket management:
Disabled
D
= no check
Short Label = it is possible to manage labels with length smaller than the distance
between the notch sensor and the printing line; the device always
performs the alignment to the next ticket and does not execute the
paper recovery after cut even if set by Windows driver. After cut paper
recovery management can be set by Windows driver or by $1C $C1
command.
5. CONFIGURATION
User manual
KPM150H 37