Cub Crafters CARBON CUB SS CC11-160, Руководство по обслуживанию

Страница: 275 / 356

CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
Manual number SSC10000AMM
6.3.17
Date: 04/18/2013 Page: 7
4 MAIN BATTERY
The battery is a 12 Volt lead acid battery. It is sealed and does not require electrolyte
replenishment. Inspect every 100 hours for physical condition and cleanliness.
(1) REMOVAL
(d) Remove the pins fr
om each side of pilot’s seat base.
(e) Slide the seat fully forward and lift the seat aft.
(f) Disconnect the battery cables and remove the battery.
(2) INSPECTION
(a) Inspect the battery and terminals for condition and corrosion.
(b) Clean as required.
(c) If necessary, charge the battery in accordance with the following instructions.
(3) CHARGING
NOTE
Charging should be conducted in an environment between 70º F and 90º F (20ºC and 30ºC).
The battery capacity may vary if charged outside of this recommended temperature range.
NOTE
If battery becomes very hot to touch, cease charging and allow battery to cool down.
NOTE
Voltage reading should be a minimum of 12.8-13.0 volts after charging. If voltage reading using
voltmeter is not 12.8 volts or more, repeat charging cycle.
(a) The battery may be charged using a 12 volt, 1 ampere battery charger.
(b) Charging time using a 1 amp charger is 4.5 hours; charging rate will vary
depending on the type of charger used. If a trickle charger is used, charging time
may be longer.
State of Charge Voltage Reading on Voltmeter (Volts)
100% 13.0
75% 12.8
50% 12.5
25% 12.2
0% 12.0 or less
Table 6.3.17.1: Battery Voltage Reading using a Voltmeter