Cub Crafters CARBON CUB SS CC11-160, Руководство по обслуживанию

Страница: 145 / 356

CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
Manual number SSC10000AMM
6.3.4
Date: 09/03/2010 Page: 5
(j) With a person holding the wing and one person holding the rear lift strut, remove
the lower and upper rear lift strut bolts and separate the strut from the fuselage.
(k) Remove the nuts from the wing and strut attachment bolts.
(l) Remove the lower and upper front lift strut bolts and separate the strut from the
fuselage.
(m) Remove the wing from the fuselage.
(n) Rest the wing on the leading edge using soft pads along the leading edge or
place horizontally on padded sawhorses so as not to dent or damage the
surfaces.
(o) Repeat the all the procedures on the opposite wing, if necessary.
(2) INSTALLATION
(a) Support the wing at the outboard end and at the wing root.
(b) Align the wing root attachment points with the fuselage attachment points and
insert bullets. (It is easier to temporarily secure the wing with bullets of the same
diameter as the bolts and then push the bullets out with the bolts.)
(c) Position the front strut fork on the fuselage attachment point and align the hole
with a bullet.
(d) Align the top hole of the front strut with the wing attachment hole and secure with
a bullet.
(e) Position the rear strut fork on the fuselage attachment point, align the hole with a
bullet; align the top hole of the rear strut with the wing attachment point and
secure with a bullet.
(f) Repeat the procedure on the opposite wing, if necessary.
(g) Apply a light coat of grease to the wing attachment bolts before installation.
(h) Press out the bullets at the wing to fuselage attachment points with the proper
bolts. Secure the bolts using the appropriate washers and nuts. Torque the nuts
to 160-200 in. lbs. (Refer to Section 5.2.8.)
(i) Press out the bullet at the wing to front strut attachment point with the proper
bolt. Slide the spacer and pulley bracket over the end and secure the using the
appropriate washer and nut. Torque to 160-200 in. lbs. (Refer to Section 5.2.8.)
(j) Press out the bullet at the wing to rear strut attachment point with the proper bolt.
Secure using the appropriate washer and nut. Torque to 160-200 in. lbs. (Refer
to Section 5.2.8.)