Cub Crafters CARBON CUB SS CC11-160, Руководство по обслуживанию

Страница: 159 / 356

CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
Manual number SSC10000AMM
6.3.5
Date: 04/18/2013 Page: 9
(4) LEFT HORIZONTAL STABILIZER INSTALLATION
(a) Apply grease (MIL-G-81322E
)
to the inside of the front and rear tubes of the right
stabilizer and install it onto the ends of the tubes that protrude from the side of
the fuselage. It may be necessary to have a second person hold the left stabilizer
as a back up.
(b) Make sure the sewn seams on the trailing edge of both stabilizers are on the
bottom.
(c) Make sure the stabilizer frame fits tightly against the fuselage attachments.
(d) If the tail surfaces have been changed and new tube liners are installed
complete the following;

Have a second person pull the front corners of the stabilizer together tight
against the fuselage attachment yoke then drill a hole down through
predrilled hole in top of the both front stabilizer tubes into the tube liner with
a #12 bit.
WARNING
DO NOT DRILL CLEAR THROUGH.

Drill the holes up from the bottom through the stabilizer and liners and on up
through the top to "clean out" the holes.
(e) Attach with a long bolt (1) and washer (3) inserted down through the stabilizer
and tube (6) and secure it with a washer (4) and nut (5). Torque the nut to 38-43
in. lbs.
(f) Pump grease (MIL-G-81322E
)
into the stabilizer link assembly grease fittings (if
equipped) until it starts to squeeze out.