Cub Crafters CARBON CUB SS CC11-160, Руководство по обслуживанию

Страница: 216 / 356

CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
6.3.10
Manual number SSC10000AMM
Page: 2 Date: 04/18/2013
1 TROUBLESHOOTING, SERVICING, AND MAINTENANCE
This section is prepared to help the owners / operators diagnose the probable causes and
determine appropriate corrective actions. For additional information on more specific trouble
shooting procedures, refer to the engine Operat
or’s Manual and their Maintenance and
Overhaul Manual.
WARNING
DO NOT ATTEMPT TO USE THIS MANUAL AS A GUIDE FOR PERFORMING REPAIR OR
OVERHAUL OF THE ENGINE. THE ENGINE OVERHAUL MANUAL MUST BE CONSULTED
FOR SUCH OPERATIONS.
PROBLEM PROBABLE CAUSE REMEDY
Reference
in this
manual
Engine does
not start Insufficient fuel. Fill tanks 6.2.3
Fuel does not reach carburetor. Clean tank vents, blowout supply
line, replace shut-off valve, repair
pump, clean filter.
6.3.15,
7*
NOTE
Carburetor float valve stuck shut. Remove carburetor and repair. 7*
NOTE
Carburetor screen or jets
plugged. Remove and clean.
6.3.15
Insufficient priming (weak
explosions). Repeat starting procedure with more
priming.
Excess priming (puffs of black
smoke). Clear cylinders by turning propeller
several revolutions, with ignition
switch "OFF", throttle wide open.
Engine hot (vapor lock in fuel
system). Disconnect fuel line at carburetor
and purge system.
6.3.15
Low battery charge Recharge battery. 6.3.17
Cold oil. Turn propeller by hand several
revolutions to break loose congealed
oil.
Incorrect starter adjustment. Readjust shift lever screw. 7*
NOTE
Spark plugs fouled. Remove and clean. Check gaps. 6.3.18
Spark plug cables defective. Replace defective parts. 7*
NOTE
Irregular
idling Incorrect idle mixture adjustment. Correct carburetor adjustment. 6.3.15
Carburetor idle air bleed
plugged. Disassemble, as required, and
clean.
7*
NOTE
Spark plugs fouled. Remove and clean. 6.3.18
Irregular
idling
Leak in air induction system. Tighten loose joints. Replace
damaged parts.
7*
NOTE
Rough
running Propeller out of balance. Remove and inspect.
6.3.16