Chapter 4. Web Configuration & Operation
21
CHAPTER 3
WEB OPERATION & CONFIGURATION
Offset settings:
Enter the number of minutes to add during Daylight Saving Time. The allowed range is 1 to 1440.
3.2.7 System Log Configuration
Configure System Log on this page.
Server Mode:
This sets the server mode operation. When the mode of operation is enabled, the syslog message will
send out to syslog server (at the server address). The syslog protocol is based on UDP communication and received on
UDP port 514. Syslog server will not send acknowledgments back to the sender since UDP is a connectionless protocol
and it does not provide acknowledgments. The syslog packet will always send out, even if the syslog server does not
exist. When the mode of operation is disabled, no syslog packets are sent out.
Server Address:
This sets the IPv4 host address of syslog server. If the switch provides DNS feature, it also can be a
host name.
Syslog Level:
This sets what kind of messages will send to syslog server. Possible levels are:
Info:
Send information, warnings and errors.
Warning:
Send warnings and errors.
Error:
Send errors only.
3.2.8 System Log Information
Displays the collected log information.
Level:
Use this pull down to display all messages or messages of type info, warning or error.
Clear Level:
Use this pull down to clear selected message types from the log.
Browsing buttons:
Use these buttons to quickly go to the beginning or end of the log or to page through the log.
