CSZ NORM-O-TEP 111Z, Руководство по эксплуатации и техническому обслуживанию

Страница: 58 / 82

Operation / Technical Manual NORM-O-TEMP, Model 111Z
Page 58 of 81
6-11. Replacement or Cleaning of the Water Flow Indicator Assembly
A. Obtain a replacement water flow indicator.
B. Drain reservoir and disconnect power cord as described in Section 5-1.4.
C. Remove the three sided enclosure panel as described in Section 6-1.3.
D. Locate the water flow indicator assembly shown in Figure 10.
E. Remove the two screws that hold the water flow indicator to the manifold pan
on the outside left wall.
F. Remove the two screws securing the water flow indicator to the back-up
manifold bracket under the rear of the reservoir.
G. Disconnect the hoses from the plastic elbows. If the water flow indicator is to be
replaced, go to step M. If the water flow indicator is to be cleaned and then
reinserted, go to step H.
H. Remove the four remaining screws around the face of the water flow indicator.
I. Disassemble the parts of water flow indicator. Do not lose large black “O” ring.
J. Rinse the parts thoroughly with clean water. A small soft brush may be used to
clean the parts.
K. Reassemble the parts.
L. Reinsert the four screws, two on each side.
M. Connect hoses from the return fitting to top plastic elbow and tighten the clamp.
N. Secure the water flow indicator to the back-up manifold bracket by inserting the
two screws.
O. Insert and tighten the two screws from the outside left wall.
P. Secure the three-sided enclosure panel as described in Section 6-1.4.
Q. Refill the water reservoir as described in Section 5-1.5.