CSG Security NetVision Plus, Руководство пользователя

Страница: 123 / 164

21-0400E v2.3.3
Welcome Common Admin Config Install
Tech-Ref 115
25.3
Wiring Reference
25.3.1
About External Alarm Inputs
Each camera can have an external sensor
associated with it (dry contact). If enabled, the
camera-view will be recorded whenever the
sensor is tripped (and if set up, a ‘pre-
recording’ of just before the event will also be
available). This can be instead of, or in
addition to video motion sensing.
Tip: External inputs can also:
•
Trigger alarm-alerts
and email;
•
Aim an associated (PTZ) camera to a pre-
defined ‘preset’ position;
•
Display the camera image
on a TV monitor until acknowledged by someone (TV-
Out / Spot Monitoring). For details, check the index for
a desired keyword.
The sensors can be either normally open, or
normally closed (as long as you 'tell' the Video
Server software which type of sensor you are
using). This is done under:
[Utility]
Ö
Recorder Setting
Ö
Alarm .
Related Topics:
18.3 External Sensors and Recording Duration
Three outputs are also included to provide
signalling functions. One output fires when
any external sensor is tripped, a second one
triggers when motion is detected in any
camera-view, and the third output is activated
when either of these conditions occurs.
The inputs and outputs are connected through
a DB connector on the back of the Video
Server.
25.2.6
RS232 – RS422/485 Converter Detail
JP1 Reference 5 4 3 2 1
Typical (default)
9
- - -
9
Half Duplex (Tx/Rx on same line)
9
-
9
-
9
Half Duplex w/RTS Control -
9 9
- -
Other Jumpers
JP2 9
(always)
JP4
9
(always)
JP3
per PTZ voltage (see diagram)
Front of NetVision
server (capture station)
Ø
Blue
Black
Red
Green
Yellow
Serial IN
(RS232)
12V Ù 5V
JP3
JP4
JP2
JP1
5 4 3 2 1