CSG Security NetVision Plus, Руководство пользователя

Страница: 118 / 164

110
NetVision Plus/Elite and Micro DVR v2.3
SP2
User's Guide
21-0400E v2.3.3
24.4.1
Status LEDs
E:
Normal/Working (Orange);
C:
Communications error (Red);
S:
Standby (Green);
T:
Trouble (Red).
25.1 Capture Board Reference
25.1.1
Introduction
Each video capture board provides a
connection for 1-4 cameras. Each Video
Server can have up to 4 capture boards for a
total of 16 cameras.
Attention:
Always remove power before attempting
to install or remove a capture board! As well,
electronic components are sensitive to static
electricity. Use proper handling methods.
25.1.2
Capture board numbering
This depends on the main board (mother-
board) provided with your Video Server:
NetVision Model Ø Capture Board #s
Elite: 2 cards, 16 cameras 1 1b 2 2b
4 cards, 16 cameras 1 2 3 4
2 cards, 8 cameras 1 2 – –
(When viewed from the rear; left to right.)
Related Topics: 25.2 Camera and PTZ Reference
25.1.3
Security Key
Each capture board includes an on-board
(USB)
security key
which is required by the
Netvision Video Server software.
Location of Security Key: Beginning in May 2006,
the security key is mounted inside the NetVision
case (near the front). For servers shipped prior to
May 2006, the key is mounted externally (plugged
into a USB port on the back of the unit).
Software Restricted Mode Error Message: If you
see an error message during start up that pertains
to "security key not found" and/or "Restricted Mode"
this may mean:
+ You reinstalled Video Server software that
supports more capture boards than you have
installed,
or
;
+ You are trying to use an incorrect type/version of
capture board;
For more information, contact your authorized
support representative.
E C S T Description
– – On –
The PC is running but the NetVision
software has not been started.
On – – – Normal operation. All systems ok.
–
Flash-
ing
– –
The Watchdog has detected an error (reset
will occur when programmed wait cycle
expires (60-250 seconds).
On – – On
The Watchdog detected an error and has
restarted the machine. To reset the trouble
LED, press the
acknowledge
button.
– On – –
A communication error has occurred.
Reinstall the NetVision software. If the
indication persists, replace the watchdog
board.
– – – – The watchdog board is not powered.
25
Hardware Reference