24
© 2022 All rights reserved. Data subject to change without notice.
LPT-M - Operation Manual
Rev. B | 2022.03
the hinges. The door should only be removed when absolutely required. Any
damage occurring from door removal procedure will not be covered under
warranty.
Grasp the door with one hand, being careful not to make contact with any of
the internal components (circuit board), and grasp the base with your other
hand. Tug on the base and pull straight apart.
DO NOT TWIST
. The section of
the hinges located on the base should “snap” apart from the part of the hinges
located on the door.
After installation, simply locate the lid hinges over the installed base hinges and
pull toward you. The hinges should easily “snap” back into place.
The enclosure has one screw securing the door to the base for electrical safety
and provides an opening to allow the user to apply a padlock or tie wrap if they
desire the transmitter to be locked. See Section 4.1 Exterior Enclosure.
Be aware that the hinged door that could potentially pinch fingers and the sharp
edges and/or jumper pins on the board could potentially prick or cut fingers if
not handled carefully.
5.5 Mounting the Transmitter
The LPT-M should be installed on a flat vertical surface using the four 4.4 mm /
0.175 in diameter mounting holes provided to maintain water tight status. Care
should be taken to ensure that the face of the LPT-M is not obstructed in order
to maximize the sensor’s exposure to the environment being monitored.
Two 12.7 mm / ½ in conduit entry points are provided in the enclosure. Both
are located in the enclosure base. One in the rear of the base and one on the
bottom edge of the base. See Section 5.6 Enclosure Mounting Components.
The clearance from the PCA to the base enclosure is 12.7 mm / ½ in.
Do not
