Crary Air Reel 1010, Руководство пользователя, Страница: 59 / 72

PN 12069 R072208 55
SERVICE & MAINTENANCE
Every 40 hours the eccentric rollers should be checked (Fig
-
ure 54). Flat wear spots may show on the eccentric rollers if
they do not rotate while the reel rotates. If this occurs it may
be necessary to make adjustments or replace the rollers and/
or bearings.
6.7 eccenTRic RolleRS (PlaSTic)
Place all controls in neutral or off, stop combine engine, set
parking brake, remove ignition key, wait for all moving parts
to stop, then properly block machine before servicing, ad-
justing, repairing, or unplugging.
WaRninG
The eccentric rollers must rotate with the reel.
imPoRTanT
Inspect the eccentric rollers for uneven wear. If no wear is 1.
detected proceed to Step 5.
If uneven wear is detected, loosen and remove the bolt and 2.
hardware for each roller that is defective.
Inspect the radial bearings that are seated in the rollers; 3.
check to see if they turn freely.
If replacement parts are needed, consult your local autho- 4.
rized Crary dealer.
Reassemble the eccentric roller assembly as shown in 5.
Figure 55.
Readjust the roller firmly against the eccentric ring and tighten 6.
bolts to the specified torque. You may need to insert addi
-
tional washers between the roller and the eccentric mount
plate to center the eccentric ring on the rollers.
Figure 54, Inspect plastic rollers for uneven wear
Figure 55, Reassemble eccentric roller assembly