Crary Air Reel 1010, Руководство пользователя, Страница: 42 / 72

PN 12069 R072208 38
ASSEMBLY
4.19 Reel To headeR inSTallaTion
Set assembled reel into the half clamps on reel support 1.
brackets so the brace clamps are inside of the reel support
brackets (Figure 36).
Center the reel between the reel arms. 2.
Slide the brace clamps out to the reel support assemblies 3.
and tighten the clamps.
Ensure the manifold can be rotated by hand and attach the
4.
half clamps to the reel support assemblies with 3/8” x 1”
carriage bolts and locknuts.
Attach hydraulic hoses to hydraulic motor. 5.
Figure 36, Reel to header installation
noTe
Bolt half-clamps from the bottom up so the nuts are on top.
Because of limited space between reel arms, on certain header
sizes the brace clamp may not be needed on the motor end
of the reel.
4.20 maniFold TilT
Slide the pivot clamp assembly over the LH end of the mani
- 1.
fold, and position it next to the reel support bracket. Do not
tighten the clamp at this time.
Place the tube cap over the end of the manifold tube and 2.
secure with an 8-3/8” t-bolt clamp.
Bolt the stationary end of the electric actuator to the clevis 3.
on the reel support bracket (Figure 37).
Rotate the manifold so the line of sight along the air tubes is 4.
directed just behind the cutterbar (See section 5.2).
Extend the actuator 1/2 the length of the full extension (ap
- 5.
prox. 2”).
Bolt the actuator to the clevis on the pivot clamp assembly. 6.
Tighten the pivot clamp assembly around the manifold. 7.
Figure 37, Manifold tilt
noTe
Be sure the reel can be rotated by hand before attaching the
actuator.
noTe
The pivot clamp assembly may serve as a clamp for the tube
cap in some instances. In this case, you would not use the
8-3/8” t-bolt clamp.
Place all controls in neutral or off, stop combine engine, set
parking brake, remove ignition key, wait for all moving parts to
stop, then properly block machine before servicing, adjusting,
repairing, or unplugging.
WaRninG