PN 12069 R072208
30
ASSEMBLY
4.13 aiR TubeS
Roll the manifold over so that the air tube holes in the bottom
1.
of the manifold are at the 12:00 position.
Apply the self adhesive foam seals (Figure 25).
2.
Remove and discard the slot and two hole cutouts
A.
from the self adhesive foam seal.
Remove the self adhesive foam seal from the back-
B.
ing and apply foam seal to manifold.
Assemble the double air tubes to the outside manifold holes
3.
(one per end):
Locate three 11/32” x 7/8” self tapping screws per
A.
each air tube.
Place an air tube on the manifold, aligning the three
B.
small holes of the air tube with the manifold.
Drive three 11/32” x 7/8” self tapping screws through
C.
the air tube into the holes of the manifold (Figure 26)
You may use an impact wrench for this step.
Follow steps A through C to install the single air
D.
tubes to all remaining manifold holes.
Make sure that the opening of the single and double air tubes
face toward the rear of Air Reel (Figure 27).
imPoRTanT
The double air tube assemblies are only installed on the
ends of the manifold (one per end) (Figure 27).
imPoRTanT
Figure 25, Apply self-adhesive foam seals
Figure 26, Fasten screws
Figure 27, Installation of air tubes
Содержание Air Reel 1010
