Crary Air Reel 1010, Руководство пользователя, Страница: 24 / 72

PN 12069 R072208 20
ASSEMBLY
4.7 RiGhT hand dRive KiT - PRe 1993 SeRieS
Install two bushings to the gearbox, aligning the keyways of 1.
the bushings with each other at the 12:00 position. Do not
tighten at this time.
Slide the gearbox drive shaft through the gearbox from the 2.
left side. Insert the 5/16” keys into the keyways of the shaft
and position the shaft so approximately 1/2” is exposed on
the RH side of the bushing.
Tighten the three bushing bolts on each side of the gearbox 3.
to 17 ft-lbs.
Slide a bushing shield weldment over the RH end of the
4.
gearbox drive shaft and secure to the RH side of the gearbox
using two 1/2” bolts and washers (Figure 12).
Check for shaft alignment up and down and in and out. 5.
Tighten the bolts securing the gearbox mounting plates to
the gearbox and the bolts securing the gearbox mounting
plates to the mount support plate. Torque the hardware to
75 ft-lbs.
Bolt the shield mount plate directly to the LH side of the
6.
gearbox.
Insert a 5/16” key into keyway at the LH end of the gearbox
7.
drive shaft. Slide the clutch end of the PTO driveline onto
the shaft. Tighten clamp bolt and set screws.
Slide the slip clutch shield over the PTO driveline and fas- 8.
ten to the shield mount plate using 5/16” x 3/4” bolts and
washers.
Place all controls in neutral or off, stop combine engine, set
parking brake, remove ignition key, wait for all moving parts to
stop, then properly block machine before servicing, adjusting,
repairing, or unplugging.
WaRninG