Crary Air Reel 1010, Руководство пользователя, Страница: 53 / 72

PN 12069 R072208 49
OPERATION
5.6 conTRolS
Before starting to work, all operators should familiarize them-
selves with the location and function of the controls and safety
devices. Some machines may vary due to different models of
combines and headers.
maniFold TilT:
Moving the toggle switch to the FORE position (Figures 48
1.
& 49) extends the shaft of the electric actuator. This directs
the air tubes toward the front of the header.
Moving the toggle switch to the AFT position (Figures 48 &
2.
49) retracts the shaft of the electric actuator. This directs the
air tubes toward the back of the header.
Figure 49, Manifold tilt/air movement
Figure 48, Manifold tilt/air volume toggle switch
5.5 neuTRal dRive ShaFT (oPTional)
When harvesting in conditions where air flow is unnecessary,
you can bypass the fan to improve combine fuel economy. To
do so, place all controls in neutral or off, stop combine engine,
set parking brake, remove ignition key, and wait for all moving
parts to stop. Then, move the driveline ends that are connected
to each end of the gearbox stub shaft to the neutral shaft located
behind the fan.
To slide a driveline on and off the splined shafts, pull back the
spring-loaded collar at the end of the driveline. After moving the
driveline to the desired shaft, release the end collar and make
sure the driveline locks into place on the shaft.
Place all controls in neutral or off, stop combine engine, set
parking brake, remove ignition key, wait for all moving parts to
stop, then properly block machine before servicing, adjusting,
repairing, or unplugging.
WaRninG
5.4.2 aFTeR oPeRaTinG FoR 2 houRS
Re-torque fasteners and hardware. 1.
Check that all safety decals are installed and legible. Apply 2.
new decals if required.
Check that no hydraulic hoses are being pinched, crimped, 3.
or are rubbing. Reroute as required.
Check that the wiring harness is not being pinched, crimped, 4.
or rubbing. Reroute as required.
Check the tension and alignment of all drive chains. Adjust 5.
as required.
The gearbox will generate heat. The typical operating tem- 6.
perature of the gearbox is 180° F.
5.4.3 aFTeR oPeRaTinG FoR 10 houRS
Re-torque fasteners and hardware. 1.
Check that all guards are installed, secured and function- 2.
ing as intended. Do not operate with missing or damaged
shields.
Check safety decals. Install new ones if required. 3.
Check the routing of hydraulic lines and the wiring harness. 4.
Reroute as required to prevent pinching, crimping, binding,
or rubbing.
Check the plastic eccentric rollers for uneven wear. 5.
Refer to the normal servicing and maintenance schedule as 6.
defined in the Service Record.
5.4 machine bReaK-in