Crane BevMax 4, Техническое руководство

Страница: 11 / 103

10
is in the blocking position, which holds the front
displayed product in position to be vended. The rear
knuckle assembly is in a flat position, which allows
product to enter the gate area, and the kicker is flush
to the rear knuckle assembly. A stainless steel pin is
inserted through the rear most portion of the front
knuckle assembly and connects to a gear box below
the tray. When a selection is made, the plunger
pushes the lever toward the back of the tray. At the
same time the front knuckle is opened into a flat
position, the rear knuckle is closed to a blocking
position, holding the remaining product out of the gate
area, and the kicker is extended to firmly push the
front displayed product off of the tray. The plunger is
energized for approximately 1-½ seconds to allow
ample time for the displayed product to be ejected
from the shelf. The plunger is then released and the
front knuckle returns to the blocking position, the rear
knuckle and kicker return to their standby position and
the next product slides into the vend display position.
SLIDE/PUSHER ASSEMBLY (Can/Bottle
Trays)
The slide/pusher is located on the bottom of each
product column. Its purpose is to provide a slick,
friction resistant surface for the product to rest on.
The tall product pusher is mounted on the top of the
slide and incorporates a coil spring in the body that
attaches to the bottom of the slide through a slit. This
spring adds needed tension to insure that all products
in the column remain tight against each other and are
allowed to progress into the gate area. Periodic
cleaning and lubrication of the slides is recommended.
DO NOT USE SOLVENTS OR ABRASIVE
MATERIALS TO CLEAN ANY PORTION OF THE
TRAY.
DELIVERY (PICKER) CUP ASSEMBLY
The delivery (picker) cup assembly is located on the
XY vend mechanism. Its purpose is to pick the
product from the column and deliver the product to the
delivery port assembly. The delivery (picker) cup
assembly is mounted on the XY assembly and bolts in
position.
The X axis runs left to right. The X axis assembly is
cabinet mounted to prevent any cabinet torque and
has one belt to synchronize the top and bottom when
the X moves left or right.
The Y axis runs up and down and has the delivery
(picker) cup assembly attached. A top channel is
used to contain and hide the e chain and wiring.
Both X and Y motors have encoders for positioning.
REFRIGERATION DECK CLAMP
ASSEMBLY
The refrigeration deck clamp assembly is located on
the rear left side of the cabinet base plate. Its
purpose is to secure the refrigeration assembly tight
against the vertical base plate for refrigerated air flow
in to the cabinet. A 7/16” wrench or socket is needed
to adjust the bolt.
BELT TENSION ADJUSTMENT
COMPONENTS
The belt tensioning adjustment components have
been revised to ease adjusting belts when needed.
The X Belt Idler Tensioning Assembly in the upper left
hand corner of cabinet now includes a thumb screw.
Adjustments should only be needed if a belt is
replaced.
The Bottom X Drive Tensioner Assembly in the lower
right hand corner of cabinet has a plastic spring
loaded tensioning wheel to keep the belt against the
pulley when moving and does not require any
adjustments.