Crane Merchandising Systems BevMAX 4 Series, Техническое руководство

Страница: 6 / 105

5 of 97
DO NOT REMOVE THE
GROUND PIN ON THE PLUG OR
IN ANY WAY BYPASS, MODIFY,
DEFEAT, OR DESTROY THE
GROUNDING SYSTEM OF THE
VENDING MACHINE
•
DO NOT USE WITH AN EXTENSION
CORD.
•
DO NOT REMOVE THE WARNING TAG
ATTACHED TO THE POWER SUPPLY CORD.
•
The GFCI must be tested frequently and before
each use in accordance with the instructions
provided on the GFCI device.
IF THE GFCI
DOES NOT PASS THE TEST, DO NOT USE
THE MACHINE
. Unplug the supply cord from
the receptacle and call the Crane Merchandising
Systems Technical Support Group for assistance
at 1-803-266-5001.
It is recommended that the machine be located so that
the GFCI device will be accessible after the machine
is installed. After installation, visually inspect the
GFCI and power supply cord to be sure it is not
crushed, pinched, or stretched.
Protect the power supply cord during transportation
and use. Periodically inspect the power supply cord
for damage. If the cord or plug is worn or damaged, it
must be replaced with a power supply cord of the
same type, size and specification as originally
provided with the machine.
DO NOT USE THE
VENDING MACHINE UNTIL THE WORN OR
DAMAGED CORD IS REPLACED.
FAILURE TO COMPLY WITH
THESE INSTRUCTIONS MAY
SUBJECT THE USER TO THE
RISK OF INJURY OR
ELECTRICAL SHOCK WHICH
CAN BE SERIOUS OR FATAL.
PERIODICALLY INSPECT THE
POWER SUPPLY CORD FOR
DAMAGE. IF THE CORD
BECOMES DAMAGED IT MUST
BE REPLACED WITH THE
SAME SIZE AND TYPE CORD.
CONTACT CRANE
MERCHANDISING SYSTEMS
FOR ASSISTANCE.
INSTALLATION AND SETUP
INSTRUCTIONS
MANUAL LOCK
Open the service door on the right side using the key
provided in the coin return cup, or if shipped with a
locking clip, remove the clip and install the lock.
Ensure there is no power to the AC Distribution Box.
On venders with a main power switch on the AC
Distribution Box the switch needs to be in the OFF
position. On venders with a main power quick
disconnect plug on the AC Distribution Box the quick
disconnect plug needs to be unplugged. Check that
all connectors are firmly seated on the control board
and at the various components on the service door
(coin mech, keypad, etc.).
Retrieve the main power plug from the hole in the rear
of the vender and plug the cord in a properly
grounded 120VAC, 15 Amp receptacle (U.S. and
Canada).
Open the service door and apply power to the AC
Distribution Box (if equipped with a bill acceptor, the
acceptor should cycle twice). The display on the door
will briefly show the software version in use as
“Software ###.## (i.e. ###.01) followed by the default
idle message “ENJOY A REFRESHING DRINK”, the
fluorescent lamp should be lit and the cooling unit
should start. If the display shows “OUT OF
SERVICE”, or the cooling unit fails to start, refer to the
TROUBLESHOOTING SECTION beginning on page
36.
SERVICE NOTE
Battery Backup
The battery backup is used to maintain the date and
time in case of power interruptions, or any time the
main power is off. When the vender is shipped, the
battery is connected and memory is being maintained.
If the vender is to be stored for long periods of time,
disconnecting the battery is recommended. The
following steps will guide you through this procedure.
•
Open the service door, turn the main power
switch to the off position or unplug the main
power harness located on the front of the
power box.
•
Locate the control board mounted on the rear
wall.
•
Remove the battery from its holder (B1).