page 8
screw
hanging
bracket
canopy
7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the
open end of the hanging bracket. Partially
loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of
slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy
to lock. Re-insert screw that was removed and
then tighten both screws securely.
Slide canopy cover up to canopy, aligning
protrusions on canopy cover with notches
in the hole in the bottom of canopy. Press up
gently but firmly on the canopy cover until it
fits into the bottom of the canopy and then
turn canopy cover to the right (clockwise)
about 1/2 in.
canopy cover
screw
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio
or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
6. Wiring. (cont.)
[PLEASE NOTE: Wall and/or handheld
remote control must be used for fan to
operate. If you do not wish to use the wall
control, please proceed to Section 7 below to
continue with fan installation.]
To install wall control, remove existing wall
switch. Wire one of the wall controls with
wire connectors provided as shown in
diagram at right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently push wires and taped wire
connectors into outlet box.
Install one 12-volt battery (included) in wall
control.
IMPORTANT: Wall control will not function
unless battery is installed.
WARNING: Battery is to be inserted with the
correct polarity.
Select a faceplate (almond or white) and
press firmly onto front of wall control.
Attach wall control to outlet box and secure
with screws from original wall switch.
Attach wall plate (included) to wall control
using 2 screws provided with the wall
control.
(wiring for wall control)
black (OUT to fan)
green
black
(AC IN from
breaker box)
black
(TO POWER supply)
black
green/
green/
bare
bare
ground
ground
green/
bare
ground
outlet box
wall
control
face-
plate
12V battery
wall plate
