page 9
9. Light Kit Assembly.
Remove 1 screw from motor plate on underside
of motor housing and partially loosen the other
2 screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing male
plug from motor housing to come through hole
in middle of fitter plate. Twist fitter plate to
lock. Re-insert screw that was just removed and
securely tighten all 3 screws with a Phillips
screwdriver.
Remove 1 screw from underside of fitter plate
and partially loosen the other 2 screws.
Connect female plug from the fitter plate to
male plug from motor housing, matching up
the colors on the female plug with the colors
on the male plug for correct fit. Be sure that
plugs connect securely.
Connect WHITE wire from LED light kit to
WHITE wire from motor housing. Connect
BLUE wire from LED light kit to BLUE (or
BLACK) wire from motor housing. Be sure
molex connections snap together securely.
WARNING: If you will NOT be using the light
kit, DO NOT connect the molex connections.
Carefully arrange wiring within fitter plate.
Align slotted holes on outer edge of LED light
kit with the loosened screws in fitter plate.
Twist LED light kit to lock. Re-insert screws
that were previously removed and tighten all
3 screws securely.
fitter plate
LED light kit
molex
connections
WHITE
BLUE
male plug
female plug
motor housing
fitter plate
male plug
motor plate
motor
housing
8. Blade Assembly.
WARNING: To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble the
blades. If screws are overtightened, blades may
crack and break.
Time Saver: Washers for blade screws can be
set on each blade attachment screw prior to
installing blades.
Locate 18 blade attachment screws and washers
in hardware pack. Slide a blade through one of
the narrow, rectangular openings on motor
housing, aligning holes in blade with holes in
blade arm (located inside the motor housing
and seen from the underside of the motor
housing)--refer to drawing at right. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat procedure for
each remaining blade.
NOTE: Tighten blade attachment screws twice
a year.
blade arm
motor housing
blade attachment screws
and washers
blade
BLUE
WHITE
["Light Kit Assembly" continued on next page.]