page 10
10. Assembly of Handheld
Remote Control.
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 10
for remote control assembly instructions. If you
have already installed the wall control but do not
wish to use the handheld remote control, please
proceed to Section 11.
Gently pull on remote control cover to separate
top and bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld
remote control, cut each wire on wall control
(that was not previously used)--use wire cutters
to cut off each wire as close to the wall control
as possible. [Refer to diagram 2.]
Install one 12-volt battery (included) in wall
control. [Refer to diagram 2.]
WARNING: Battery is to be inserted with the
correct polarity.
["Assembly of Handheld Remote Control"
continued on next page.]
9. Light Kit Assembly. (cont.)
If you wish to USE the light kit, align grooves
on shade with nodules on inside of fitter
plate and push up gently on shade. Turn
shade to the RIGHT (clockwise) until shade
locks into place.
Pull down VERY GENTLY on shade to make sure
shade is secure.
If you do NOT wish to use the light kit,
align
grooves in metal cover with nodules on
inside of fitter plate. Push up on metal cover
and then turn metal cover to the
RIGHT
(clockwise)
until it no longer turns.
WARNING: Be sure
molex connections for
LED light kit are NOT connected if you do
NOT wish to use the light kit.
WARNING
: Metal cover will be HOT if light
is left on.
motor
housing
shade
groove
nodule
nodule
fitter plate
metal cover
motor
housing
groove
fitter plate
(top)
(bottom)
remote control
cover
diagram 1
wall control
wire
wire
wire
12V battery
diagram 2
