page 11
10. Assembly of Handheld Remote Control. (cont.)
Attach black faceplate to front of wall control; press
down firmly. [Refer to diagram 3.]
Align holes in wall control with posts located on
inside of TOP part of remote control cover and press
together firmly. Place wall control into BOTTOM part
of remote control cover, aligning posts in top of
remote control cover with post holes in the bottom.
[Refer to diagram 3.]
(NOTE: Make sure to align narrower ends of remote
control cover before closing.) Squeeze top and
bottom of remote control cover together until you
hear a click at each end, indicating that the remote
control cover has closed completely.
IMPORTANT: Store the handheld remote control away
from excess heat or humidity. To prevent damage to
handheld remote control, remove battery if handheld
remote control will not be used for long periods.
NOTE
: Remove batteries with low or no charge and
dispose of properly.
CAUTION: “DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK.” - When disposing
of household alkaline batteries, it is best to check with
your local and state recycling or household hazardous
waste coordinators concerning the specifics of the
program in your area. You may also locate a recycling
center by calling 1-800-8-BATTERY or
1-877-2-RECYCLE or visit
www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
WARNING: Choking Hazard - Small parts. Keep
batteries away from children.
WARNING: Batteries are NOT rechargeable.
Non-rechargeable batteries are not to be recharged.
wall
control
face-
plate
remote control
cover, BOTTOM
post
hole
post
hole
remote control
cover, TOP
diagram 3
11. Automated Learning Process./Activating Code.
CAUTION: The wall and/or handheld remote control can be programmed to multiple receivers or
fans. If this is not desired, turn wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall control to
the ON position. Within 60 seconds of turning on the wall control, press and hold the OFF
button on the wall control for 5 seconds (or until light blinks twice or fan blades begin to
turn).
Turn power off again for at least 5 seconds and then turn power back on. Within 60 seconds
of restoring the power, press and hold the OFF button on the front of the handheld remote
control for 5 seconds (or until light blinks twice or fan blades begin to turn).
Test the light and fan functions to confirm the learning process is complete--see Section 14
(page 13).
