page 9
11. Automated Learning Process./
Activating Code.
CAUTION
:
The remote control transmitter can be
programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover on back side of remote
control transmitter.
Use a ballpoint pen or a small screwdriver to set the
code switches 1 through 4 for the transmitter.
Use
the same number sequence used when wiring the
wall control in Section 6 (page 6).
Note
: Since this fan comes with a halogen bulb, the
dimmer switch (labeled
D
and
X
) has been pre-set
to the "ON" position (
D
). If you do not wish to have
dimming capability, please move the switch to the
"OFF" position (
X
).
Install one 12-volt battery (included) in transmitter.
Re-attach battery cover on transmitter.
Restore electrical power and then set slider switch
on wall control to the ON position. Within 30
seconds of turning on the wall control, press the
fan "OFF" button ( ), located on the front of the
transmitter, for 5 seconds or until light blinks twice.
Test the light and fan functions to confirm the
learning process is complete--see Section 14.
battery
cover
12V battery
dimmer
switch
code
switches
transmitter
(
back
)
transmitter
(
front
)
12. Wall Control Operation.
ON/OFF slider switch
- turns
wall control
ON or OFF
HIGH
button - turns
fan
to HIGH speed
MED
button - turns
fan
to MEDIUM speed
LOW
button - turns
fan
to LOW speed
OFF
button - turns
fan
OFF
L
button - turns
light
ON/OFF when pressed once;
dims
light
when pressed and held down
