6. Wiring. (cont.)
page 6
IN ORDER TO WIRE WALL CONTROL
, remove
existing wall switch. Wire the
WALL CONTROL
with wire connectors provided as shown in
diagram at right.
* Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into
outlet box.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 on the wall
control. Factory setting is pre-set and not
recommended for use.
Write down number
sequence for use in Section 10.
Note
: Since this fan comes with a halogen bulb,
the dimmer switch (labeled
D
and
X
) has been
pre-set to the "ON" position (
D
). If you do not
wish to have dimming capability, please move
the switch to the "OFF" position (
X
).
Install one 12-volt battery (included) in wall
control. Attach wall control to outlet box and
secure with screws from original wall switch.
Attach front plate to wall control using 2 screws
provided in the wall control.
Important
: Wall control will not function unless
battery is installed.
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio
or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
black (OUT to fan)
green
black
(AC IN from
breaker box)
black
(TO POWER supply)
(wiring for wall control)
black
green/
green/
bare
bare
ground
ground
green/
bare
ground
outlet box
wall
control
plate
1 2 3 4 X
D
code
switches
12V battery
dimmer
switch
antenna
7. Canopy Assembly.
Raise canopy to hanging bracket and align
slotted holes in canopy with loosened screws
in hanging bracket. Twist canopy to lock.
Re-insert screws that were previously
removed (page 3, Section 4) and secure all
screws with Phillips screwdriver.
*Remember that antenna for remote control
receiver must rest
outside
of hanging bracket.
canopy
hanging bracket
