page 10
HI
button - turns
fan
to HIGH speed
MED
button - turns
fan
to MEDIUM speed
LOW
button - turns
fan
to LOW speed
button - turns
fan
OFF
button - turns
light
ON/OFF when tapped quickly.
Pressing and holding button down for more than
0.7 seconds converts it into a dimmer.
13. Remote Control Operation.
reverse switch
diagram 1
motor
housing
(
topside
)
remote control
transmitter
wall
control
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Locate ON/OFF slider switch on
wall control and set to the ON position. Test light and
dimmer function and then test fan speeds. Next, locate
remote control. Start with the light OFF and test the
light ON/OFF function by pressing the button. Test
the dimmer function by pressing the button and
holding it down for 1 second. Test fan speeds with the
different fan speed buttons. (
diagram 1
) If the remote
control operates all of the functions of the fan, battery
has been installed correctly. If the wall and/or remote
control do (does) not operate all of the fan functions,
refer to "Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off
before
moving the reverse
switch (located on top of the motor housing).
(
diagram 1
) Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting in
winter without feeling a difference in your comfort.
Important
: Reverse switch must be set either
completely to the LEFT
or
completely to the RIGHT
for fan
to function. If the reverse switch is set in the
middle
position (
diagram 4
), fan will not operate.
NOTE
: If the remote control interferes with other
appliances, change code switches on the transmitter to
another code. If you do change the code,
turn power off
first
, remove the battery cover, and, after setting the
new code, go back to the instructions in the last
paragraph of Section 11 (page 9).
14. Testing Your Fan.
diagram 2
diagram 3
diagram 4
