Country Clipper CHALLENGER D510, Руководство по эксплуатации продукта, Страница: 39 / 96

5.16
Left Rear Height of
Cut Adjusting Bolt
Left Front Height of
Cut Adjusting Bolt
Deck Leveling Adjustment
(Note: The deck has been factory leveled. If leveling is required follow this procedure.)
5.9.36 Locate Mower on Hard Level Surface… Locate mower on a hard level surface, engage Park Brake
and shut the engine off.
5.9.37 Confirm Tire Pressure… Set the tire pressure on each of the four tires to 12psi (83kPa). (Make
sure all four tires are equal).
5.9.38 Set Cut Height To 3 Inches… Set the deck cutting height to 3 inches and rotate the two outside
blades by hand until one end of each outside blade points forward (toward the front of tractor).
5.9.39
Ground to Blade Tip Measurement…
Measure from the ground to the front blade tip on each
outside blade of the deck. These measurements should be approximately 3 inches and within 1/8
inch of each other.
( Note: To simplify this measuring, an optional Blade Measuring Tool, part number 629-374A is
available from your local Country Clipper Dealer).
( Important: Do not attempt to set the deck cut height higher or lower than specified. This could
cause failure of the deck drive system.)
5.9.40
Front Deck Height Of Cut Adjustment…
If adjustment is needed; turn the Height of Cut Adjusting
Bolt clock-wise to raise the deck, turn the Height of Cut Adjusting Bolt counter clock-wise to lower
the deck so the blade height is approximately 3 inches. Make sure the left and right side
measurements are within 1/8 inch from one side to the other.
5.9.41 Rear Blade Tip Measurement (Deck Rake)… Measure the rear blade tip height from the ground
on both sides of the deck. The rear blade tip height should be equal or greater than the front
blade tip height. Country Clipper recommends that the rear blade tip measure 1/8 to 1/4 inch
higher than the front blade tip measurement.