COSMOGAS FRYO 6PI, Инструкция по установке, использованию и техническому обслуживанию

Страница: 21 / 60

21
FRYO PI
COSMOGAS
5.4 - Choosing the installation location

The appliance must be installed in open spaces, corridors,
balconies, roofs or vertical walls.

The appliance must be installed in a ventilated and
weather-protected location. If installed in a humid place,
the electronic components could deteriorate and short
circuits could occur.

The appliance must not be installed in a place with the
presence of corrosive or flammable gases.

In order to avoid acoustic discomfort, it is preferable to not
install the device near bedrooms or living rooms.

Install the appliance at least 50 cm from the ground in case
the climatic conditions are severe: temperatures below zero
and high humidity.

Install the device at a minimum of 50 cm higher than the
typical snow level.

Install a cover on the appliance to prevent snow from
occluding the air intake and air outlet (Figure 5-6).

Make sure that there is the possibility of drainage around
the appliance to evacuate condensation during the
defrosting process.

Install the appliance away from the kitchen air outlet. The
oily fumes could enter the appliance and adhere to the
evapo-condensing battery.

Install the appliance in a place not humid and not corrosive,
in order to not shorten its operating life.

Drill holes for connecting the slightly inclined pipes (> 8 °)
to prevent rainwater from entering (Figure 5-6).

Install the appliance in a place protected from the rain
(Figure 5-6).
Figure 5-8 - Installation on a raised floor
Figure 5-7 - Holes closure (B) and drainage fitting (A)
5.5 - Condensate drain assembly
The appliance is designed for conveying and draining the
condensate that forms on the battery. To do this, close the
unused drain holes (B) and insert the condensate drain fitting
in the desired hole (Figure 5-7).

It is recommended to mount the drainage fitting in position
“A”, as shown in the Figure 5-7.

It is recommended to seal the caps (B) and the condensate
drain fitting (A) with silicone.

Tilt the appliance by 1 cm / m in the direction of the drainage
fitting to facilitate the evacuation of the collected water.
B
A
B
B
020031.01.002
Figure 5-6 - Example of outdoor installation
Cover
Sleeve
5.6 - Mounting the appliance
Observe the following instructions during installation (Figure
5-8):
- Install the appliance on a concrete floor or masonry blocks
or a metal bracket;
- If use a metal bracket, it must ensure a support weight of at
least 5 times that of the appliance;
- The bracket can be made of galvanized steel, aluminum or
other materials that do not degrade over time;
- In the case of wall mounting, choose a support suitable for
the weight of the appliance;

During installation, tilt the condensate collection pipe by
1 cm / m to facilitate the drainage of rainwater.
5 - INSTALLATION