COSMOGAS FRYO 6PI, Инструкция по установке, использованию и техническому обслуживанию

Страница: 31 / 60

31
FRYO PI
COSMOGAS
7.2.4 - Setting the setpoint temperature in
heating / cooling / DHW
You can adjust the domestic hot water temperature between
20 ° C and 75 ° C, but a temperature above 55 ° C can cause
malfunctions.
The maximum temperature that can be set in heating is 42 °
C. It is possible to increase this temperature up to 55 ° C by
modifying the “C5” parameter (section 7.5).
WARNING !!! If the outdoor reset is activated
(section 7.4, Parameter “d1” = 1) it will not be possible to
modify the setpoint heating temperature, because it will
be calculated according to what is set in the parameters
between “d1” and “dC” (section 7.4).
The minimum temperature that can be set in cooling is 7 ° C.
When an operating mode is selected (section 7.2.3), the
relative setpoint temperature must be set, proceed as follows:
1.- Press the “SET” button to activate the temperature
settings, the symbol relating to the operating mode and the
temperature to be set will start flashing;
2.- Press and buttons to increase or decrease the
setpoint temperature;
3.- Confirm by pressing “SET”, the symbol of the next operating
mode will flash, then proceed as in the previous points.
Figure 7-7 - Setting the setpoint temperature
Press “SET” to switch to the various temperature settings of the different operating modes
in sequence
7 - USE