COSMOGAS FRYO 6PI, Инструкция по установке, использованию и техническому обслуживанию

Страница: 23 / 60

23
FRYO PI
COSMOGAS
5 - INSTALLATION
5.7.1.- Display installation in a remote
position
To install the display in a remote you need to:
1.- Open the display protection flap (detail “3” Figure 3-1);
2.- Disassemble the front part of the display by levering with
a cutter in the four corners, as in the Figure 5-11;
Figure 5-11 - Removal the front of the display
Figura 5-12 - Removal the rear part Figure 5-14 - Remove, from the inside appliance,
the display cable
Figure 5-13 - Remove the upper and front cover
3.- Disconnect the cable from the display and remove the rear
part by unscrewing the two screws (Figure 5-12);
4.- Mount the rear part to the display and the screws to the
casing of the appliance, in the same position, to fix the
structure of the display protection flap;
5.- Remove the upper and front cover of the appliance, so as
to be able to access the internal components (Figure 5-13);
6.- From the inside of the appliance, remove the cable that was
connected to the display and bring it inwards (Figure 5-14);
7.- Pass the cable through the grommet of the terminal block
and take it towards the outside of the appliance;
8.- Connect the 10 m extension cable, located inside the
accessories bag, to the terminal of the cable and connect
it to the display;
9.- Now it is possible to mount the display on the wall and
away from the appliance.

Install the display in a dry place inside a room.