Coronis MDCC 2121, Руководство по началу работы

Страница: 46 / 94

Connecting the signal cables
46
Connecting the signal cables
To connect the signal cables to the display:
1.
Make sure the computer is turned off.
2.
To get access to the connectors, remove the connector
compartment cover (1).
To remove the cover, gently pull the bottom side of the cover
upward or firmly press down the 2 clips at the top side
(positions marked in the plastic).
3.
To facilitate cable routing afterwards, remove the tilt & swivel
neck cover (2). Therefore, first tilt the display panel in upright
position. Then lift and pull backward the neck cover.
4.
Also to facilitate cable routing afterwards, open both cable duct
covers (3).
Figure 25: Remove covers before connecting signal cables
1
2
3
3