CONVEY-ALL 2245-TL, Руководство оператора

Страница: 31 / 58

Operator’s Manual: 2200-TL Series Conveyor
Revised 06.2016 3-13
Fig 37 - Working Conveyor
3.7.2 Stopping Conveyor:
1. Stop unloading. Wait for conveyor belt to empty.
2. Stop the conveyor belt.
3. Move the throttle to idle position.
4. Turn off engine and remove ignition key.
3.7.3 Emergency Stopping:
Although it is recommended that the tube be emptied
before stopping, in an emergency situation, stop or
shut-down the engine immediately.
See to the emergency.
Correct before resuming work.
3.7.4 Restarting after Emergency Stop:
When the machine is shut down inadvertently or in
an emergency, the conveyor belt will still be covered
with material.
Since start-up torque loads are much higher than
normal when belt is full, restart at a low engine speed.
Remove as much product from the hopper as
possible.
3.7.5 Unplugging:
In unusual moisture, crop or material conditions,
the machine can plug. When unplugging, follow this
procedure:
1. Stop the conveyor belt.
2. Throttle down. Then, top the engine.
3. Lock-out, tag-out the controls.
4. Remove material from discharge and hopper area.
5. Reposition unit if discharge area plugs due to
lack of clearance.