Control 4 C4-KNX-BW180 Series, Руководство пользователя

Страница: 31 / 53

Description of application and parameters
Application program
31
NOTE
This parameter is displayed only when automatic switch-on/switch-off has been
activated and/or when the external push-button has been activated.
Options: No
Yes
–
No : There is no separate status manual on/off object for monitoring the status of the control.
–
Yes : A 1-bit status manual on/off communication object (output) is being enabled. This
object sends an On telegram when the movement detector is deactivated and only one
manual operation is possible via the external push-button input. If this object sends an Off
telegram, the movement detector switches back to automatic mode.
Options: 00.100 .. 01.250 .. 59.999
– The set pause time is started after the detector has been switched off due to expiry of the
switch-off delay or when a switch-off telegram is received on objects external push-button or
actuator status.
If movement is detected during this time, the detector is not switched on immediately. The
pause time is first extended by 7 seconds. If there is still movement after these 7 seconds, the
detector switches back on.
If no movement is detected during the pause time, the detector is ready for activation again after
the pause time.
This behaviour can, for example, be important when the lamp cools down drastically and is
located within the detection range of the detector. Without a blockage there would be an
unintentional switch-on. The purpose of pause time is to prevent an immediate re-activation.
Example:
A person switches the light off manually when leaving the room. Without the pause time the
detected movement would cause a renewed switch-on during exiting.
NOTE
■
The external push-button object is activated under the "External push-
button" parameter.
■ The actuator status object is activated under the status display parameter.