Control 4 C4-KNX-BW180 Series, Руководство пользователя

Страница: 9 / 53

Notes on the instruction manual
9
Fig. 1: Product overview
[1] Support ring
[2] Cover frame (not included in scope of delivery)
[3] Flush-mounted insert (with integrated cover)
The movement detector (passive infrared detector) responds as soon as heat is registered in
the detection range and triggers a switching process. It can send switch-control telegrams to
KNX actuators. To switch on the lighting, for example. If the heat source leaves the detection
range or remains motionless, the lighting is switched off after an adjustable switch-off delay.
In addition to the detection of movement, the sensor can with the aid of its integrated message
function detect movements within a specific time with only a minimum of sensitivity. This allows
the sensor to be integrated in message systems.
The movement detector has a twilight sensing function. This function triggers the surveillance
function when the adjustable brightness values are exceeded or fall short (ambient brightness).
The parameters in the Engineering Tool Software (ETS) can be used to set the switch-off delay
and the brightness limit value of the installed twilight switch.
Use ETS 5.6 or higher.
The movement detector is anti-glare, i.e. when a light beam enters (e.g. with a flashlight), the
surveillance function is maintained for approximately 90 seconds.
The devices do not serve as a substitute for an alarm system.
The sensor is integrated in a flush-mounted insert [1].
The integrated bus coupler makes possible the connection to the KNX bus line.