Control 4 C4-KNX-BW180 Series, Руководство пользователя

Страница: 17 / 53

Notes on the instruction manual
17
To start the device a physical address must be assigned first. The physical address is assigned,
and the parameters are set with the Engineering Tool Software (ETS).
Use ETS 5.6 or higher.
NOTE
The devices are products of the KNX system and meet KNX guidelines. Detailed
expert knowledge by means of KNX training sessions for a better understanding
is assumed.
1. Connect a PC to the KNX bus line via the KNX interface.
– The Engineering Tool Software must be installed on the PC (ETS 5.6 or higher).
Download from: https://ctrl4.co/knx-bw180 (KNXPROD File Name: SBW/U1.1.41-83).
2. Switch on the bus voltage.
1. Press the programming button [1] on
the rear of the device.
– The red programming LED [2] on the
front of the device lights up.
2