EPIQ 5 & 7 Training Manual
© 2016 Conquest Imaging
71
Low humidity (hot and dry conditions)
Improper grounding
Unshielded cables
Poor connections
Use the following precautions in order to reduce ESD:
Wrist straps
Antistatic mats
Antistatic spray on carpets or linoleum
Before handling a board or you can touch a grounded surface such as
the power supply housing to discharge any built-up charge.
Fire Safety
The following general fire safety practices are relevant for all
electrical equipment.
If there is any evidence of smoke or fire disconnect system power
immediately.
On electrical or chemical fires use only extingushers that are
specified for this use. Using water or other liquids is very
dangerous and can lead to injury.
General Cautions
Batteries must be handled as hazardous waste. Check that the
cases are intact and the terminals are clean. Follow your facilities
procedures regarding disposal should they become damaged.
If the system has been stored below 10°C allow it to reach room
temperature before connecting or turning on to prevent
damaged caused by internal condensation.
The flat panel display can be damaged if stored where
temperature can reach 65°C.
System transductors cannot be cleaned/decontaminated by any
sort of heat process. Refer to manufacturer’s specifications and
hospital procedures for the particular transducer.
All manuals and user guides at all-guides.com
