DX-1S Digital PABX - Programming Manual
5-48
5.7.33 PROGRAMMING ITEM 132 : PCM SERVICE STATUS
This is to program the service status of PCM card.
Command
3 * 132 * Index1 * Value <Enter> or
3 * 132 * Index1 * Value * Index2 <Enter>
where Index1 = 1 ~ 60 PCM Trunk no.
Index2 = 1 ~ 60 PCM Trunk no. <Optional>
Value = 1 : enable , 0 : disable
Default Value
Value = 0
5.7.34 PROGRAMMING ITEM 133 : NUMBERING SCHEME
This item is to program the system to use flexible Numbering Scheme or normal Numbering Scheme.
Normal Numbering Scheme is the system default numbering scheme, please refer to Operation Manual –
Feature Access Code section for detailed information.
Usually there are two reasons to use flexible Numbering Scheme.
1.
The normal numbering scheme is not suitable, you want to re-arrange the Feature Access Code.
2.
In a networking system, a flexible numbering scheme is required to access the other networked
module. See Programming Item 138: Flexible Range Stop for example of using Flexible Numbering
Scheme.
Command
3 * 133 * Value <Enter>
where Value = 0 : normal numbering scheme
Value = 1 : flexible numbering scheme
Default Value
Default = 0
Related Topic
1.
Programming Item 134: First Digit Type
2.
Programming Item 135: DISA Digit Type
3.
Programming Item 136: Flexible Format
4.
Programming Item 137: Flexible Range Start
5.
Programming Item 138: Flexible Range Stop
5.7.35 PROGRAMMING ITEM 134 : FIRST DIGIT TYPE
This item programs the system how to interpret the first digit dialed by an extension when Flexible
Numbering Plan is enabled.
In a flexible numbering scheme system, system will interpret the first digit to corresponding value as
following :