Mounting Instruction
Conductor rail system
MultiLine 0835
MAL0835-0001c-EN
www.conductix.com
translated document
page 54 of 81
CAUTION!
When replacing the end caps with intermediate power feeds, the conductor rail will become approx.
40 mm shorter.
→
The 1
st
section must be installed as described in section 6.2.
CAUTION!
Do
not
fit the end caps on the final segment. The end caps on the end cover plate are replaced with
power feed connectors and caps after installation of the second section.
→
To install the 2. section, replace the arrester with screw clamps from the start of the 1. section to the start of the 2. section.
CAUTION!
Fit section 2 in the same way as section 1.
→
Remove the arrester with the screw clamp once the 2
nd
section and end section has been fitted.
→
Connect both sections with the intermediate power feed 081551_....
Installing the intermediate power feed 081551_...
The two sections must be connected as follows:
→
Unclip the conductor rail form the hanger clamps for 1 - 2 m to the left and right of the connection point.
→
Loosely connect the connecting cable's ring terminal with the power feed's screw connection:
→
Remove square nut
→
Attach ring terminal
→
Loosely tighten nut by hand
→
Insert the clamping parts of the two power feeds into the end of the end section of section 1.
Fig. 48: Move conductor rail
1
2
3
1
2
3
Item
Name
1
Connector
2
Clamp wing
3
Conductor rail
