Operating Instructions
LASSTEC
Weighing System 0521
BAL0521-0001-EN
www.conductix.com
translated document
page 10 of 123
2.3
Equipment Security
The equipment has been exclusively designed and constructed for the intended purpose.
WARNING!
Danger caused by application not in accordance with regulations!
Each application of the equipment not in accordance with and/or different from the regulations can
result in dangerous situations.
Therefore:
Only use the equipment in accordance with the regulations.
All details of these mounting and operating instructions must be strictly observed.
The following applications of the equipment are prohibited. Applications not in
accordance with regulations are as follows:
Application of the equipment with accessories not permitted or authorized by the manufacturer.
Operation of the equipment by not instructed personnel.
Exceeding / be lower than projected supply voltages.
Changing of the delivered software modules.
Changing, bridging and/or deactivation of control circuits or interlocking.
Bridging and/or deactivating electrical sensors or switches.
Use of non-approved protective devices.
Re-adjustment of protective devices.
2.4
Safety Measures by the Operator
The equipment is used in the commercial sector. The operator is therefore responsible for occupational safety. Besides the safety advice
of these mounting and operating instructions he must observe the safety, accident prevention and environmental protection regulations
effective for the range of application of this equipment. Please note in particular:
The operator must read the valid work safety regulations and determine any additional dangers in a risk assessment, dangers that
might arise from special working conditions at the place of installation of the equipment. He then must work out the operating
instructions for handling the equipment.
During the complete operating time the operator must check if his operating instructions are in accordance with the state of technology
of rules and standards and adapt them if required.
The operator must clearly regulate and establish the responsibilities for installation, handling, fault repair and maintenance.
The operator must ensure that all employees who are handling the equipment, have read and understood these mounting and
operating instructions. Moreover he must instruct the personnel at regular intervals and inform them about any dangers.
The operator must have checked all safety devices regularly for their operational capability and completeness.
