Operating Instructions (GB)
900 191 - V1.0
_________________________________________________________________________________
Page 3
1.
General notes
The control system has been developed according to the state of the art, was manufactured
with the greatest of care and is subject to continuous quality controls.
The purpose of these operating instructions is to make it easier to get to know the device and
to make full use of its intended applications.
These operating instructions contain important information for a safe, proper and economical
operation of the devices. You must follow these operating instructions to ensure a reliable,
long service life for the devices and to avoid hazards.
The operating instructions do not take into account any location provisions, which are the
responsibility of the operating company, as well as the installation personnel.
The devices must not be operated above the values stated in the technical documentation
regarding operating voltage, nominal frequency of the network, ambient temperatures,
switching performance and other instructions contained in the operating instructions.
Should there be additional information or instructions required, or in the event of a claim,
please contact the manufacturer.
2.
Safety instructions
This documentation refers exclusively to the control system and contains basic instructions
that must be observed during the installation, operation and maintenance thereof. Therefore it
is essential that these operating instructions are read by the technician and other responsible
specialist personnel/operators before installation and commissioning; it must be available at
the system's operating site at all times.
You must not only observe the general safety warnings given in the main "Safety" section, but
also the special safety warnings included under the following main points.
2.1
Identifying instructions in the operating instructions
The safety information given in these operating instructions, which can cause danger to
persons upon failure to observe, are specially marked with the following symbols.
Warning of common hazards
Warning of high voltage
2.2
Personnel qualifications
The operation, maintenance, inspection and installation personnel must have the appropriate
qualifications for their specific work. The scope of responsibility, competence and supervision
of the personnel must be defined in detail by the operating company. Should the staff not have
the proper knowledge, additional training and instructions must be scheduled. Furthermore,
the operating company carries the responsibility that the content of these operating
instructions is fully understood by the staff.
2.3
Risks in case of non-observance of these safety warnings
Non-observance of the safety warnings may lead to hazards for personnel, as well as for the
system itself. Non-observance of safety warnings will result in loss of any rights to claim
damages.
In particular, non-observance may lead to incidents such as the following:
-
Failure of key functions of the device
-
Failure of prescribed methods for monitoring
-
Danger to personnel by electrical forces
