Condair Nortec EL-Series, Руководство по эксплуатации и обслуживанию

Страница: 65 / 96

65 Maintenance Nortec EL
2582954_D_EN_1811_Nortec-EL_OM
6.3 Maintenance Procedures
Make sure that the humidifier is shut down properly as described in "Shutting Down" on page 62 , and ob -
serve all safety precautions before performing any maintenance work on the humidifier.
6.3.1 Removal and Installation of Door Panels
Removal
Remove the two door panels in the humidifier as follows. Refer to Figure 11 .
1. Turn the captive screw in each door panel counter-clockwise with a screwdriver.
2. Lift up the door panel slightly so that the tabs clear the notches in the cabinet, then carefully remove
the panel.
Figure 11:
1
2
3
4
5
6
7
Door Panels Removal and Installation
1 Stationary panel
2 Door panel, control cabinet
3 Captive screw
4 Door panel, plumbing cabinet
5 Top tab, door panel
6 Long tab, door panel
7 Notch, cabinet
Installation
Install the two door panels in the humidifier as follows. Refer to Figure 11 .
1. Position each door panel so that the two tabs in the top rear of the panel align with the notches in
the cabinet.
2. Lower the door panel to seat the tabs in the notches, while ensuring that the long tab on the side of
the panel slides behind the stationary panel.
3. Make sure that the door panel fits flush on the front and the side. Turn the captive screw in the door
panel clockwise with a screwdriver to secure the door panel. Check that it is fastened securely.