Condair Nortec EL-Series, Руководство по эксплуатации и обслуживанию

Страница: 31 / 96

31 Operator Interface Nortec EL
2582954_D_EN_1811_Nortec-EL_OM
Operation Tab, continued...
– Overcurrent:
CAUTION! Do not adjust this value unless instructed to
do so by a Condair representative.
Setting range: 0.0-2.0
Factory setting:
1.5
– Low Conductivity: allows you to adjusts the end-of-
cylinder-life detection to prevent false end-of-cylinder-life
detection when conductivity of the supply water is less
than 250 μS/cm.
Options:
On
– use when conductivity of the
supply water is less than 250 μS/cm.
Off – use when conductivity of the
supply water is greater than 250 μS/
cm.
Factory setting: Off
– Short Cycle: allows you to enable or disable the function
that enforces a time delay between the humidifier stopping
and restarting steam production (to reduce mechanical
wear on contactors and other peripheral devices). This
function is typically used with On/Off controllers. It can also
be useful if a high limit humidistat is cycling the humidifier
on/off too frequently.
Options:
On
– the humidifier runs in short
cycle mode.
Off – the humidifier cycles normally.
Factory setting: Off