Condair Nortec EL-Series, Руководство по эксплуатации и обслуживанию

Страница: 39 / 96

39 Operator Interface Nortec EL
2582954_D_EN_1811_Nortec-EL_OM
Multi-Unit Operation Tab
– Linkup: allows you to enable or disable the Linkup func -
tion, which allows up to six humidifier to connect and
operate together from a single control signal. It also allows
you to designate the humidifiers to operate as the main or
extension unit(s).
Options:
Main
– designated as the main (mas -
ter) unit.
Ext 1 – designated as the first exten -
sion unit.
Ext 2 – designated as the second
extension unit.
Ext 3
– designated as the third ex -
tension unit.
Ext 4
– designated as the fourth
extension unit.
Ext 5 – designated as the fifth exten -
sion unit.
Off – disables Linkup. The humidifier
performs as a single unit.
Factory setting:
Off
Note:
The remaining settings in this tab are only available
on the main unit when Linkup function is enabled.
– Linkup Units: allows you to set the number of humidi -
fiers in the Linkup chain.
Setting range:
1-6
Factory setting: 1
– Linkup Type: allows you to select the mode of opera -
tion of the humidifier in the Linkup chain.
Options:
Parallel
– the humidity demand (from
a single zone) is distributed evenly
on all humidifiers in the Linkup chain.
Series – the main unit operates to its
maximum capacity, and as demand
increases the extension units gener -
ate steam in sequential order. Each
unit scales steam production in small
increments. Series setting maximiz -
es turndown.
Independent – should not be used
for Linkup.
Factory setting:
Series
– Sequence Rotation: allows you to enable or disable
the function that manages the starting order to balance
operating hours of all linked humidifiers. Note: This
setting is available only if Linkup Type is set to "Series".
Options:
On
or
Off
.
Factory setting:
On
Refer to "Configuring for Multi-Unit Operation" on page 55 for setup
procedure.