Conair Carousel Plus UGD043-1216, Руководство пользователя

Страница: 31 / 176

3
Installa
tion
I n s t a l l a t i o n l
3-7
Connecting the Main Power
CAUTION: Always disconnect and lock out the main power sources before making electri-
cal connections. Electrical connections should be made only by qualified personnel.
1
Open the dryer’s electrical enclosure. Turn the disconnect dial on the dryer door to the
Off or “O” position. Lock out the main power. See Introduction: How to Use the
Lockout Device for complete lock out information.
Turn the captive screw, and swing the
door open.
2
Insert the main power wire
through the knockout in the side of the enclosure. Secure
the wire with an appropriate strain relief.
IMPORTANT:
Always refer to the
wiring diagrams that came with
your dryer before making electrical
connections.
3
Connect the power wires
to the three terminals at the top of the power disconnect hold-
er.
4
Connect the ground wire
to the ground lug as shown in the photo.
✐
NOTE: Models
W600-5000 con-
figured with
process heat and a
Heater Pack at the
hopper will require
conduit from the
control panel to
the Heater Pack
.
See the Appendix,
in this User Guide
for more informa-
tion about proper
conduit and cable
size for your
application.
OFF
O
ON
I
✐
NOTE:
Wiring between process air heater, Heater Pack, and dryer where control for this heater is
located is not included. Maximum working distance is 100 feet {30 meters}. Consult Conair or a
qualified electrician to determine gauge of wire required for distance.