Comtech EF Data MetaCarrier MCDD-100, Инструкция по установке и эксплуатации

Страница: 22 / 88

MCDD-100 MetaCarrier Detection Device Revision 3
Introduction MN-MCDD100
1–8
1.3.3.2 Rear Panel
PROPER GROUNDING PROTECTION IS REQUIRED. The equipment must be connected
to the protective earth connection at all times. It is therefore imperative that the unit
is properly grounded, using the ground stud provided on the unit rear panel, during
installation, configuration, and operation.
• Sect. 3.2 MCDD-100 Connector Overview
• Sect. 3.5 MCDD-100 Grounding and Power Connections
Figure 1-5. MCDD-100 – Rear Panel View
External cables are attached to connectors provided on the rear panel of the unit. The unit
provides the following standard interfaces (Figure 1-5, from left):
Power Interface:
•
100–240 VAC Primary Input Power Supply with Press-fit Fuse Holder.
IF Interfaces:
•
IF Operation: 50 MHz to 180 MHz via dedicated
50Ω or
7
5Ω
Type BNC connector (‘Rx
(IN) | 70-140 MHz’ port).
•
L-Band Operation: 950 MHz to 2150 MHz via dedicated
50Ω
Type ‘N’ connector (‘Rx (IN)
| L-BAND’ port).
Utility Interfaces:
• (1X) D-Sub, 9-pin male (DB-9M) EIA-232 connector for serial remote control (‘CONSOLE’
port).
• (1X) D-Sub, 15-pin male (DB-15M) connector for provision of the Rx MetaCarrier IQ
constellation for troubleshooting purposes (‘MONITOR’ port).
•
(1X) 10/100 BaseT Fast Ethernet RJ-45 Interface for HTTP and SNMP management and
control purposes (Web and SNMP) (‘ETHERNET MANAGEMENT’ port).