Comtech EF Data LPOD PS 1, Инструкция по установке и эксплуатации

Страница: 151 / 238

Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Revision 15
Serial Interface Operation 5–31 MN-LPOD
Parameter
Type
(* indicates
End-of-Life)
Controller-to-Target
Instruction Code and
Qualifier
Arguments
for Command
or Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
(see Description of
Arguments)
Command Query
Response to
Command
Response
to Query
Retrieve
Configuration
Status
N/A RCS? 45 bytes Query only.
Returns the configuration status of the unit.
EXAMPLES:
<0001/RCS?{CR}
ATT=12.75{CR}
AMP=1{CR}
MUT=1{CR}
ONL=1{CR}
ESW=1{CR}
AOF=00.00{CR}
AFR=1{CR}
XRF=NA{CR}{LF} (SEE NOTE)
Where:
ATT= attenuation in dB
AMP= RF power amplifier state where 0=OFF, 1=ON
MUT=RF mute state where 0=unmuted, 1=muted
RED=Online status for redundancy
ESW=Redundancy and mode states where 0=OFF, 1=ON Tx only, 2=ON Tx & Rx
AOF=Attenuator Offset in dB
AFR= auto fault recovery where 0=manual, 1=auto
XRF=External reference status where NA=no external reference, 05M=5 MHz,
and 10M=10 MHz
NOTE: XRF will always be NA if the internal reference oscillator option is not
installed.
RCS= RCS=x….x
Online Status RED= RED? 1 byte Command or Query.
Sets or returns Redundancy Online status in the form x, where:
0=Offline
1=Online
NOTE: This command is functionally identical to the ONL command.
COMMAND EXAMPLE: <0001/RED=1{CR}
RED=
RED?
RED*
RED=x