Comtech EF Data LPOD PS 1, Инструкция по установке и эксплуатации

Страница: 139 / 238

Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Revision 15
Serial Interface Operation 5–19 MN-LPOD
Parameter
Type
(* indicates
End-of-Life)
Controller-to-Target
Instruction Code and
Qualifier
Arguments
for Command
or Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
(see Description of
Arguments)
Command Query
Response to
Command
Response
to Query
Set RTC Date
(by Day)
DAY= DAY? 6 bytes Command or Query.
Sets or returns the Reasl-Time-Clock date in the form ddmmyy, where:
dd=day of the month (01 to 31)
mm=month of the year (01 to 12)
yy=year (00 to 99) (2000 to 2099)
COMMAND EXAMPLE (date=April 25, 2016): <0001/DAY=250416{CR}
DAY=
DAY?
DAY*
DAY=ddm
myy
Enable
Statistics
Averaging
ESA= ESA? 1 byte Command or Query.
Enables or Disables averaging of statistics data, at a rate of once per second
every 10 seconds, in the form x, where:
0=Disable (DEFAULT – SEE NOTE)
1=Enable
NOTE: If Disabled, burst values will be logged instead of averaged values.
COMMAND EXAMPLE: <0001/ESA=0{CR}
ESA=
ESA?
ESA*
ESA=x
Enable
Statistics
Logging
ESL= ESL? 1 byte Command or Query.
Sets or returns the statistics logging function in the form x, where:
0=Disable (DEFAULT)
1=Enable
COMMAND EXAMPLE: <0001/ESL=1{CR}
ESL=
ESL?
ESL*
ESL=x
Enable
Redundancy
Switch Mode
ESW= ESW? 1 byte Command or Query.
Sets or returns the redundancy state in the form x, where:
0=Off (DEFAULT)
1=1:1 Redundancy Tx (Only Tx switch installed)
2=1:1 Redundancy Tx + RX (Tx and RX switch installed)
5=1:1 Manual redundancy mode (used for debugging, or redundancy system
setup) (SEE NOTE)
NOTE: Manual redundancy does not support automatic switching, and the offline
unit will not poll the online unit to update its configuration.
COMMAND EXAMPLE: <0001/ESW=1{CR}
ESW=
ESW?
ESW *
ESW=x