Comtech EF Data LPOD PS 1, Инструкция по установке и эксплуатации

Страница: 142 / 238

Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Revision 15
Serial Interface Operation 5–22 MN-LPOD
Parameter
Type
(* indicates
End-of-Life)
Controller-to-Target
Instruction Code and
Qualifier
Arguments
for Command
or Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
(see Description of
Arguments)
Command Query
Response to
Command
Response
to Query
Management IP
Address
IPA= IPA? 18 bytes Command or Query.
Sets or returns the Management IP Address and network prefix for the ‘J6 |
COM1’ 10/100 BaseT Ethernet management port, in the form xxx.xxx.xxx.xxx.yy,
where:
xxx.xxx.xxx.xxx=the IP Address
yy=the network prefix (8 to 30)
Default value: 192.168.001.004.24
COMMAND EXAMPLE: <0001/IPA=192.168.001.004.24{CR}
CAUTION: Changing the Management IP Address through the Telnet interface
requires you to power cycle the unit, and then restart a new Telnet session with
the new IP Address. The IP Address that you type into the Telnet client software
does not include the range parameter so it would be: 192.168.1.4
IPA=
IPA?
IPA*
IPA#
IPA=xx.xxx
.xxx.xxx.yy
Gateway IP
Address
IPG= IPG? 15 bytes Command or Query.
Sets or returns the Gateway IP address for the 10/100 Base Tx Ethernet
management port, in the form xxx.xxx.xxx.xxx.
Default value: 192.168.001.005
COMMAND EXAMPLE: <0001/IPG=192.168.001.005{CR}
IPG=
IPG?
IPG*
IPG=xxx.xx
x.xxx.xxx
Initialize
Statistics
Pointer
ISP= N/A None Command only.
Resets the internal pointer to allow RNS? queries to start at the beginning of the
stored statistics log. This command takes no arguments.
EXAMPLE: <0001/ISP={CR}
ISP=
ISP?
ISP*
N/A