Comtech EF Data CDM-750, Инструкция по установке и эксплуатации

Страница: 156 / 300

CDM-750 Advanced High-Speed Trunking Modem Revision 2
Ethernet-based Remote Product Management MN-CDM750
6–14
6.5.4.2.2 Admin | SNMP
•
Sect. 5.2.2.9.2 (CONFIG) IP Config: SNMP in Chapter 5. FRONT PANEL
OPERATION
•
Sect. 6.3 SNMP INTERFACE
The Administrator must use this page to manage the CDM ‐ 750 SNMP (Simple Network
Management Protocol) settings.
Figure 6-4. Admin | SNMP page
SNMP
•
Use the Simple Network Management drop ‐ down list to select Enabled or Disabled .
•
Enter a Read Community string. This string can be any combination of characters and a
length of 0 to 20 characters. The factory default SNMP Read Community string is public .
•
Enter a Write Community string. This string can be any combination of characters and a
length of 0 to 20 characters. The factory default SNMP Write Community string is private .
•
Enter an SNMP Contact, Name, and Location. Each string can be any combination of
characters and a length of 0 to 20 characters.
•
Use the Enable Authentication Trap drop ‐ down list to select Enabled or Disabled .
•
Enter the Trap IP 1 and Trap IP 2 addresses, in the form XXX.XXX.XXX.XXX, for the computer
that is to receive the traps generated by the CDM ‐ 750.
•
Use the Trap Version drop ‐ down list to select SNMPv1 or SNMPv2 .
•
Enter a Trap Community String . This string can be any combination of characters and a
length of 0 to 20 characters. The factory default SNMP Write Community string is comtech .
Click [Submit Admin] to save these settings.