Comtech EF Data CDD-880, Инструкция по установке и эксплуатации

Страница: 210 / 234

CDD-880 Multi Receiver Router MN-CDD880
Appendix G Revision 2
G–16
• Ethernet-based Simple Network Management Protocol (SNMP) using a Network
Management System (NMS) and Management Information Base (MIB) File Browser.
•
Serial-based Remote Control Interface using a terminal emulation program or Windows
Command-line.
COMTECH EF DATA RECOMMENDS USE OF THE ETHERNET-BASED SNMP INTERFACE
AND SERIAL-BASED REMOTE CONTROL INTERFACE ONLY FOR ADVANCED USERS.
COMTECH EF DATA STRONGLY ENCOURAGES USE OF THE CDD-880 AND CDM-840
HTTP INTERFACES FOR MONITOR AND CONTROL (M&C) OF THE CDD-880 OR
CDM-840.
THE HTTP INTERFACE FIGURES FEATURED THROUGHOUT THIS APPENDIX ARE
INTENDED FOR USER REFERENCE ONLY AND ARE SUBJECT TO CHANGE. THE
FIRMWARE INFORMATION (I.E., REVISION LETTERS, VERSION NUMBERS, ETC.) AS
DISPLAYED MAY DIFFER FROM YOUR SETUP.
G.4.1 Dynamic Power Control Operation – HTTP Interfaces
YOU MAY PROCEED WITH ETHERNET-BASED REMOTE PRODUCT MANAGEMENT
(HTTP OR SNMP), ASSUMING THAT:
• YOU ARE OPERATING THE CDD-880 WITH THE LATEST VERSION FIRMWARE FILES.
•
YOU HAVE CONNECTED THE CDD-880 TO A USER-SUPPLIED, WINDOWS-BASED PC
AS FOLLOWS:
O
THE PC SERIAL PORT IS CONNECTED TO THE CDD-880 REAR PANEL ‘CONSOLE’
PORT WITH A USER-SUPPLIED SERIAL CABLE.
O
THE PC ETHERNET PORT IS CONNECTED TO THE CDD-880 REAR PANEL
‘ETHERNET | TRAFFIC/MANAGEMENT | GE’ ETHERNET M&C PORT WITH A
USER-SUPPLIED HUB, SWITCH, OR DIRECT ETHERNET CABLE CONNECTION.
O
THE USER PC IS RUNNING A TERMINAL EMULATION PROGRAM (FOR
OPERATION OF THE CDD-880 SERIAL INTERFACE) AND A COMPATIBLE WEB
BROWSER (FOR OPERATION OF THE CDD-880 HTTP (WEB SERVER)
INTERFACE).
•
YOU HAVE NOTED THE CDD-880 MANAGEMENT IP ADDRESS USING THE CDD-880
SERIAL INTERFACE.
• YOU HAVE INSTALLED AND ENABLED THE OPTIONAL VIPERSAT MANAGEMENT
SYSTEM (VMS).
Figure G-9 shows the CDD-880 and CDM-840 HTTP Interface “splash” pages, and the menu tree
diagrams for accessing DPC operation. Page functionality not specific to DPC operation appears
dimmed in these diagrams.
Dynamic Power Control and ACM work independent of one another. This gives you the option to
run DPC with or without ACM. This section assumes all other operational parameters have been
previously configured.