Comtech EF Data CDD-880, Инструкция по установке и эксплуатации

Страница: 179 / 234

CDD-880 Multi Receiver Router MN-CDD880
Appendix E Revision 2
E–5
• Serial-based Remote Control Interface using a terminal emulation program or Windows
Command-line.
COMTECH EF DATA RECOMMENDS USE OF THE ETHERNET-BASED SNMP INTERFACE
AND SERIAL-BASED REMOTE CONTROL INTERFACE ONLY FOR ADVANCED USERS.
COMTECH EF DATA STRONGLY ENCOURAGES USE OF THE CDD-880 HTTP
INTERFACES FOR MONITOR AND CONTROL (M&C) OF THE CDD-880.
THE HTTP INTERFACE FIGURES FEATURED THROUGHOUT THIS APPENDIX ARE
INTENDED FOR USER REFERENCE ONLY AND ARE SUBJECT TO CHANGE. THE
FIRMWARE INFORMATION (I.E., REVISION LETTERS, VERSION NUMBERS, ETC.) AS
DISPLAYED MAY DIFFER FROM YOUR SETUP.
E.4.1 Port Diversity Operation – CDD-880 HTTP Interface
Figure E-4 shows the CDD-880 HTTP Interface “splash” page, and the menu tree diagram for
accessing Port diversity operation. Page functionality not specific to Port diversity operation
appears dimmed in this diagram.
Figure E-4. CDD-880 HTTP Interface – Splash Page and Port Diversity Operation
Menu Tree (FW Ver. 1.6.2.X)
Use the CDD-880 HTTP Interface ‘ Configuration | Interface | Ethernet’ page ( Figure E-5 ) for the
operation of the Port Diversity feature.
As shown in Figure E-5: Use the drop-down list in the
Port Diversity Configuration
section of this
page to Enable or Disable this feature. Click [Submit] to save.
With Port Diversity disabled , each port has its own IP Address and Subnet. Traffic pertaining to
that subnet is routed over that physical interface, and manual routes can be routed to either
port.