C
omrex
C
orporation
56
Once your remote connection entry is correct, it’s simply a matter of point-
ing and clicking to connect and disconnect a remote. When a connection
is attempted, the
Current State
value in the connection table will change
to reflect the progress of the connection. If the connection fails, the rea-
son for failure will be shown in the
Last State
category. If it succeeds, the
encoder and decoder mode will be reflected in the
Transmit
and
Receive
Status
columns.
Disconnecting is just as simple — Highlight the desired connection and
click
Disconnect
to end the connection.
The
Connection Password
function can be used to filter incoming BRIC
IP connections (but not POTS calls). Using this function, attempted incom-
ing connections will be rejected if they do not know the proper case-sen-
sitive password. For outgoing connections, the password is entered when
the remote connection is created on the
Store New Remote
menu (#2 in
Figure 28). For incoming connections, the password is set on the
System
Settings Tab
(#1 in Figure 29). There isn’t any way to retrieve a forgotten
password; it must simply be changed in each ACCESS.
d
ISconnectIng
P
ASSWord
F
IlterIng
A
dvAnced
c
onnection
o
Ptions
Warning: Advanced Topic
